[evoelf]

Hi all, I brought an IS200 last week. From what i can gather the lights behind the clocks have been changed from orange to blue.

For the last week everything has been fine not one thing i could fault, but the other night i was on my way home and the lights behind the rev counter started to blink.

I adjusted the dimmer and reduced the brightness and it stopped... turn it back up and it starts blinking again

If it was my 3 series i'd of had the clocks out but being new to the lexus i dont feel confident about toying to much & wanna see if anyone has had a similar problem.

Would anyone advise putting the replacing the blue bulbs with standard again?

Thanks in advance

[WylieCoyote]

Is the car known to LOC do you know? Try ringing the previous owner and see what he/she says about it.

Welcome by the way

Keith

[evoelf]

WylieCoyote, on Aug 14 2007, 12:37 PM, said:

Is the car known to LOC do you know? Try ringing the previous owner and see what he/she says about it.

Welcome by the way

Keith

Got no idea if its known here... Brought the car from a dealer near my office. I've got no idea where he picked it up from.

Its the only evidence of a mod i can find on the car. Other than the blue lights the car is completely stock.

How simple is it to remove the clocks?

[Moffet]

Not difficult to remove mate, and if I remember rightly the bulbs are all twist locks into the back so you don't have to open up the binnacle. Obviously this depends on how it was modded though.

Think I've got a guide on how to do it in my bookmarks on my home computer - will post a link up when I'm at home later on...

[Moffet]

Sorry I didn't get this posted up yesterday, had computer problems!

Look here.

[Rob]

you might find its one of the sh.....te kits from ebay - if it is throw it in the bin thats where it belongs!

[evoelf]

I dont believe its an ebay kit.

I couldn't see half my clocks last night so I took the clocks out this morning before work & it seems like the bulbs have been replaced with some cheapo LEDs.

I was having a browse last night and found this site DashLights.com - 509T / 286T Bulbs.

From what i've read they seem to be a direct replacement. Can anyone confirm that it is this type of bulb?

Cheers

[Rob]

thats the style of bulbs but from what i remember the standard fit bulbs are flush mount instead of having a small piece to grab hold of

[evoelf]

Cool. Gonna stop at maplins on the way home and a small car shop in crayford (the guy has loads of different types of bulbs).

If there's none there then i'll be ordering a few from dashlights.co.uk

[kev dood]

Just a thought, but if its ok when you turn the brightness control down a little, but its not good when on full - could it be the little potentiometer that controls the brightness - i.e. whats behind this knob?

Sometimes the wiper section on them corrode a little if they remain in the same place forever.

[evoelf]

Sorted... I picked up some clear replacement & spare bulbs. The 3 main bulbs that light the clocks are the same fitment as the side indicator and the sidelights in the headlamp.



A solid improvement if i dont say myself

Also changed the sidelights

[Rikos]

Looking good mate glad you got it sorted

[Fin_IS_200]

Looking this picture, are the bulbs for the meters under that panel ? Approx how many or even better if someone can find a pic.

And are they all 5mm Twist Fit

Thanks

[evoelf]

Fin_IS_200, on Aug 17 2007, 02:28 PM, said:

Looking this picture, are the bulbs for the meters under that panel ? Approx how many or even better if someone can find a pic.

And are they all 5mm Twist Fit

Thanks

There are 20 bulbs in total.



All of the bulbs circled in red are 5mm. The bulbs circled in green are 10mm.

I dismantled the clocks last night to see if there were any aditional bulbs that could be replaced but all i could find is what is highlighted on the pic above, so i'd assume that they would include the bulbs for the meters. But i could be wrong

I paid £1 a bulb. Hope this helps

[Fin_IS_200]

Okay, Thanks, i still have to know which bulb is for what. Guess ill just take it off today.

[evoelf]

Fin_IS_200, on Aug 17 2007, 03:24 PM, said:

Okay, Thanks, i still have to know which bulb is for what. Guess ill just take it off today.

There should be a label printed on the PCB next to each bulb

[WylieCoyote]

So I assume that by replacing the lamps you could make the dash any colour you wanted?

[Fin_IS_200]

Pretty much yes.

Theres 5 bulbs for the backround lighting. 2x 5mm and 3x 10mm.

Can someone confirm that ? cause i didnt change the bulbs yet...

[evoelf]

Fin_IS_200, on Aug 20 2007, 02:18 PM, said:

Pretty much yes.

Theres 5 bulbs for the backround lighting. 2x 5mm and 3x 10mm.

Can someone confirm that ? cause i didnt change the bulbs yet...

Yup its those 5. When I changed mine they were the only bulbs that had been replaced with blue LED's.

All of the others were still clear.

[Fin_IS_200]

I just searched ultraleds.co.uk and aceparts.com, and i just cant find those 10mm twist-fit bulbs

509T stands for the 5mm twist-fit right ? So where to get 10mm ?

Thanks