open drivers side door and remove key from ignition switch
insert key to be programmed into ignition switch then remove it
Within 40 seconds
1. Press lock and unlock on the vehicle door control switch at 1 second intervals 5 times
2. Close and reopen drivers door
Within 40 seconds
1. Press lock and unlock on the vehicle door control switch at 1 second intervals 5 times
2. Insert key into ignition switch
3.Switch ignition ON and OFF once to program new key code whilst retaining the original codes or twice to program a new key code whilst erasing the original codes.
4. Remove key from ignition switch.
System should now lock and unlock car once or twice depending which mode has been selected
Within 40 seconds
1.Simultaneously press and hold key lock and unlock buttons for a maximum of 1.5 seconds.
2.Within 3 seconds press any key button for a minimum of 1 second.
System should now lock and unlock car once
Note:if system locks and unlocks car twice,progranmming procedure has not been completed.Repeat programming procedure
and get the car start
TO PROGRAMME IMMOBILIZER
Insert programmed black key into ignition switch
Within 15 seconds
1. Press and release accelerator pedal 5 times
Within 20 seconds
1. Press and release brake pedal 6 times
2. Remove black key
Within 10 seconds
Insert black key to be programmed into ignition switch
Within 10 seconds
Press and release accelerator pedal once. Immobilizer warning light will flash
After 1 minute Immobilizer warning light will extinquish.
To exit programming mode:remove ignition key and press brake pedal atleast once with 10 seconds or wait 10 seconds
I tried reprogramming an old remote (I had from a former Is200 i wrote it off) that I placed in a new key shell. The remote lock when worked fine after a few times.
i did find out that what is meant by « 3.Switch ignition ON and OFF once to program new key code whilst retaining the original codes or twice to program a new key code whilst erasing the original codes « is that it will erase the codes from the orignal key. So I had then to reprogram that one.
However I can’t get the immobiliser programmed in my old remote, from my old written off Lexus (R.I.P).
is that normal or should I keep trying? Done it about 10 time with no success
Programming New Key Fob Help!
in Lexus IS200 / Lexus IS300 Club
Posted
I tried reprogramming an old remote (I had from a former Is200 i wrote it off) that I placed in a new key shell. The remote lock when worked fine after a few times.
i did find out that what is meant by « 3.Switch ignition ON and OFF once to program new key code whilst retaining the original codes or twice to program a new key code whilst erasing the original codes « is that it will erase the codes from the orignal key. So I had then to reprogram that one.
However I can’t get the immobiliser programmed in my old remote, from my old written off Lexus (R.I.P).
is that normal or should I keep trying? Done it about 10 time with no success