Do Not Sell My Personal Information Jump to content


Power steering pump not inline, need help


T-Risely
 Share

Recommended Posts

So. I had the opportunity to replace the power steering pump on my IS200 that's done 150,000 miles with a newer pump that's only done about 70. Being a freebie I didn't pass it up. Anyways, after fitting the newer pump and putting the belt on, after tensioning it right (and before anyone says its not too tight, it's actually on the loose side), you can visibly see that the power steering pump pulley isn't lining up straight with the water pump pulley and the belt is slightly skee-wiff.

20170130_135940.jpg

20170130_142316.jpg

The bracket it mounts to is tight to the block. I've found, when I tighten the bottom bolt of the pump, it causes it to 'pull' inward and goes out of line. Any help would be massively appreciated.

Link to comment
Share on other sites


Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share



×
×
  • Create New...