Sign in to follow this  
Kyu

Dome light switch travel

Recommended Posts

I've looked around for an answer beforehand but no luck, sorry if this has been covered before.

My dome light runs perfectly, however when the switch is either set to "on" or "door" the switch skips over the connection resulting in a momentary flash. The switch can be held on the right spot to activate but the tension in the switch will pull it past contact.

Is there anything that can be done to adjust the contact or or limit the travel?

Thanks in advance.

Share this post


Link to post
Share on other sites
 

Any thoughts, guys?

Share this post


Link to post
Share on other sites

It may just be as simple as bending the contacts/copper strip a bit - get in there and experiment with it :smile:

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this