AdBlock Warning

Parts of this website do not function properly with AdBlock enabled on your device. To get the best user experience on our website, please disable Adblock for this website (domain) on your browser.


Sign in to follow this  

Replacing IS250 / IS200d / IS200d Rear Brake Pads


Description

Replacing IS Rear Brake Pads

1.remove back wheel

2. Inspect Pad Thickness

Minimum Thickness : 1.0mm (0.039 in)

3.Remove Anti-Squeal Spring And Pad Guide

NOTICE

. Do Not deform the clip and anti-sqeal spring

.The anti-squeal clip and spring can be used again, provided that they have sufficient rebound, no-deformation, cracks or wear, and have had all rust, dirt and particles cleaned off.

4.Remove Pads And Anti-Squeal Shims

5.Check Disc Thickness And Runout

6.Install New Pads

HINT

.Make sure the arrows on the inner anti-squeal shims facing to the direction of disc rotation

.Preess in the pistons with a wrench handle or equivelant(tape the end of the tool with tape)

.If the piston is difficult to push in, loosen the bleeder screw

7.Install Pad GuidePin And Anti-Squeal Spring

8.Install Rear Wheel TORQUE TO: 103Nm (1,050Kgf.cm, 76 ft.lbf)

9.Depress Brake Pedal Several Times

10.Check That Fluid Level Is At Max Line


 Report this tutorial


0 Comments

There are no comments to display.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now