|
LOC we have a problem!
IS200/300/SC/SPORT
LOC we have a problem, if you are reading this article then you also have
a problem.
Tyre wear on the Lexus delivers much d...
    |
Last
Modified:
2005-11-16 |
Number
of views:
4469 |
|
|
|
How To: Change Headlight & Parking Light Bulbs
This tutorial is based on my 1991 LS400
It took me less than 20 minutes total to remove, clean up and put both sides back together. You'll need: Phillips scr...
|
|
Last
Modified:
2005-10-03 |
Number
of views:
14564 |
|
|
|
How To: Replace Thermostat
This tutorial is based on my 1991 LS400
(Drain about 1/2 a gallon of coolant from the radiator if you want to avoid any spills). I was a little lazy and kind of forgo...
|
|
Last
Modified:
2005-10-03 |
Number
of views:
4244 |
|
|
|
How To: Flush Radiator Coolant
This tutorial is based on my 1991 LS400
You'll need:
2 gallons of Toyota antifreeze
2 gallons of DISTILLED water
about 10ft of 1/2" diameter tubing
R...
|
|
Last
Modified:
2005-10-03 |
Number
of views:
6315 |
|
|
|
How To: Bleed Brakes
This tutorial is based on my 1991 LS400
Bleed your brakes in this order: rear left, rear right, front right, front left.Jack up the car and start with the rear left w...
|
|
Last
Modified:
2005-10-03 |
Number
of views:
5002 |
|
|
|
How To: Change Transmission Fluid Through Radiator
This tutorial is based on my 1991 LS400
You could work on it without having to jack up the front end...I had mines up because I was doing an oil change.Loosen...
|
|
Last
Modified:
2005-10-03 |
Number
of views:
6385 |
|
|
|
How To: Change Motor Oil & Oil Filter
This tutorial is based on my 1991 LS400
Jack up the car or drive it up on ramps then loosen oil fill cap and set aside or just kind of lay it there like I did...
|
|
Last
Modified:
2005-10-03 |
Number
of views:
9674 |
|
|
|
How To: Change Fuel Filter
This tutorial is based on my 1991 LS400
Fuel filter is located in front of the drivers side rear wheel.Remove splash guard:
Loosen the fuel...
|
|
Last
Modified:
2005-10-03 |
Number
of views:
6813 |
|
|
|
How To: Change Transmission Filter & Pan Gasket
This tutorial is based on my 1991 LS400
Unscrew the 14mm drain bolt on this pan and drain out all the existing fluid:
Torque specs : 15ft lbs
Remo...
|
|
Last
Modified:
2005-10-03 |
Number
of views:
4683 |
|
|
|
How To: Change Differential Oil
This tutorial is based on my 1991 LS400
You'll need:
(2) quarts Gear Lube GL5
(1) 10mm hex socket
(2) crush washers
Keep the car on a flat level surfa...
|
|
Last
Modified:
2005-10-03 |
Number
of views:
4804 |
|
|
|
How To: Change PCV valve
This tutorial is based on my 1991 LS400
Use pliers to loosen clamp (slide the clamp up about 2") then remove the hose leading to the PCV valve.
...
|
|
Last
Modified:
2005-10-03 |
Number
of views:
5559 |
|
|
|
How To: Flush Power Steering Fluid
This tutorial is based on my 1991 LS400
Use a pump to remove all the power steering fluid from the resevoir then remove that hose (under the green arrow) from the power steer...
|
|
Last
Modified:
2005-10-03 |
Number
of views:
8557 |
|
|
|
How To: Remove Rear Seats
This tutorial is based on my 1991 LS400
Grab these tabs on both sides and just pull up on them...mines came right off, but you might have to use a crowbar or something s...
|
|
Last
Modified:
2005-10-03 |
Number
of views:
6184 |
|
|
|
How To: Remove Painted Pinstripes
You'll need: Masking tape Paper (1) can of Easy-Off oven cleaner (use the yellow can)I tested this on the gas cap door first just to make sure it wouldn't damage my paint (i...
|
|
Last
Modified:
2005-10-03 |
Number
of views:
6633 |
|
|
|
How To: Timing Belt & Water Pump
This tutorial is based on my 1991 LS400
Tools required :
Breaker bar
Socket wrench
A couple of extenstions
Torque wrench capable of reading at least 181 lbs
Sockets...
|
|
Last
Modified:
2005-10-03 |
Number
of views:
29233 |
|
