Anyone recognize this wire clip please

[Tomfromfife]

Hi,

Does anyone recognize the part in the attached photo, which I found under our CT200h on the garage floor. It would have dropped

from under the front seat area. I have checked a couple of part diagrams online without success.

Thanks

[colin79666]

Doesn't look grubby enough to me to have been something on the underside of the TBH. Can't think of something in the engine bay that shaped that could have snapped and fallen through.

[Tomfromfife]

The car has only done 1600 miles and clean underneath. It looks a bit tacky to be from a Lexus so maybe nothing to do with the car.

I will get the dealer to have a look at the next service.

[cruisermark]

the pieces holding bulbs within the headlight are normally of similar shape?

[200h]

 lucky you found it on the floor and not in your tyre.

[Tomfromfife]

Thanks for the replies

I think the headlight bulbs are a bayonet type fitting and this clip would be too large.

Yes, I wouldn’t have liked that through the new Cross Climates !

[me140]

It looks a bit like a wiring harness support - the other end will have a loop on it with a bolt through it - sometimes used on oxygen sensor wiring to keep the wires off the exhaust.  If I get a minute I will have a look at mine tomorrow

[Tomfromfife]

Thanks,  me140, that would be greatly appreciated. If you can get a photo if you find it I would be grateful.

 

[me140]

Is that it? Looking down the back of the engine on the drivers side. I can only see one but there should be one for each oxygen sensor. 

[Tomfromfife]

Very similar. I will check it out. Thanks

[Tomfromfife]

Ok, found that bracket and it’s still intact.

i can’t see the one on the passenger side but will check tomorrow.

Part numbers are 82715-47390 and 80

Thanks for looking and for the photo.

[me140]

Next one will be further down the exhaust after the cat. Might have to crawl underneath 

[Tomfromfife]

I found both clips in place so I think I will stop worrying about it. Here are the positions of the clips in case anyone needs to find them.

One behind the engine block as me140 has shown, on the drivers side, and the other next to the catalytic converter. Thanks for all the help.