Best Way To Fix Number Plate

[spoofer]

I have a new private plate

need to fix using diferent holes on boot would drilling new holes be a good idea ?or is there other way of fixing

kind regards

[SteveAudioX]

Oach... No extra holes.

I have some special DD tape that sticks very very well.. It's for number plates water proof etc..

[Monster-Mat]

why not use the original holes

[Chris.S]

I went to Halfords and bought some trim refitting tape, that did the trick

[Whitebeam]

For a genuine new car look (as seen at my local vauxhall dealer) fit with two mismatched self tapping screws. Plates must be slightly off centre and at an angle. For the full effect, burr over the philips slot by using the wrong screwdriver and crack the plate around the holes by overtightening.

Saw a number like this last year. Obviously left the job to the trainee.

Seriously - use tape, no holes.

[keywest]

The folk who made my personal plates put some double sided tape on the back for me (I had to ask mind you). Then just be careful

[spoofer]

I used number plate double sided tape bought from alfords b4

wouldnt hold the plate at all

Is there any stronger tape anyone can recomend and where can i buy

Kind regards

[Risky3301]

I used fancy plates at fancyplates.com you could try contacting them and ask them to send you the double sided pads they use when they supply number plates

[jac114]

i have a chrome surround around my rear plate i used the holes for the numberplate to hold that on so i had to stick mine on with sticky tabs.. its been on about a year now..so all is fine sticking them on

[lexi1]

I dont no exactly what it is called but their is definetly a double sided tape available especially for fitting no. plates. When i took delivery of my private reg with plates included there were 6 strips of ds tape supplied. 3 per plate. Like the guys say propably the same stuff they sell in Halfords.

[spoofer]

Thanx lads

for all your help

[TheDon]

I used number plate double sided tape bought from alfords b4

wouldnt hold the plate at all

Is there any stronger tape anyone can recomend and where can i buy

Kind regards

you must not have cleaned the area b4! not much will stick to old wax and dirt, lol.

I have always used Halfords pads, the 6mm thick variety. and they are great, they hold my new plate on and even the front on standard mounting! just remember to give it a good clean and use all 3 pads to attach the plate! dont scrimp and cut em up

[spoofer]

New plate on with the sticky tape

obviously before i never cleaned the area properly

cheers lads