Amp Choices

[si's_lex]

there was mention of drilling the existing hole so i could fit the power cable through as well using the exisiting gromit.

is this not the case. i have not started drilling anything yet.

[redz_UK]

there was mention of drilling the existing hole so i could fit the power cable through as well using the exisiting gromit.

is this not the case. i have not started drilling anything yet.

no drilling required mate..

just look for the big grommet below where the Battery was..

use something sharp to make a hole but dont go to deep or u may cut the loom, the just feed the power cable through.. its a 10 min job to get it into the boot...

i used some silicon sealer around where the cable goes through the grommet to seal it back up.. did a perfect job if u ask me!!

[Baldylocks]

Guessing that you have read my Workship Tip - just use the drill bit. If you twist the grommet round about 90 degrees, there is a hole already there which is currently sealed, you just need to pierce it with the drill bit.

[si's_lex]

ahhhhhhhhhh right i get you now. lol. so if i was to feed it through where in the footwell does it come out. is it obvious or do i need to remove the kickwell panels?