Got All My Parts

[Mbay]

Just picked up a new bonnet, got a new grille and got a new slam panel.

How do i install them? Any guides on here?

[mikey's IS]

Take bonnet off by undoing 2 bolts at the top of each corner by windscreen then lift bonnet off you will need a hand as trying to hold the bonnet and undo the bots may end badley, Reverse this to fit new one.

Take old grille out undo 3 clips at the top of grille Left, Centre and Right push the grille at the bottom towards the car to release slide clips there. Reverse this to fit new one.

Slam panel centre undo bolts above the headlamps that hold this section in also remove rad brackets and air scoop there are more towards the centre section and the T peice that holds the lock mech in place there is a bolt behind the lock which you will have to get a spanner in there undo this and pull lock forward a little the cables for the lock run under the slam panel so you have to push the clips out for this also. Reverse this to fit new one.

[iceman67]

you remembered how we stripped yours then mike after the bump :winky:

[Mbay]

When doing the center panel, if i take the bolts off that need to, will anything fall out like the aur scoop or radiator etc?

[Mbay]

Just fit the bonnet. But wait..........

It wont lock on the catch properly.

What do i do?

[mikey's IS]

if you still have the bent slam panel it wont.

you need to fit all the new parts then fine adjust everything