Clond

Does anyone know the bulb number for the heater lights that show up on ignition. I recently bought the drivers dash kit led's which are t5's t10's etc: What are the heater lights ? kind regards !

That's an SXE10 Altezza code. Are you sure the 4 pot altezza clutch is identical to the 6 pot GXE10 codes ?

Ok - what did you go for - looking on the boasch website it'll either be an S4 or an S5. What amperage/hour did you go for ?

Might be needing a new battery ... Does anyone know the amperage rates or a code standard for the battery - not to convinced the dealer battery would be any better that a three year garauntee version tyre dealer. Altezza aren't quoted but IS200 is - the thing is, having a 200 watt amp and speakers and a pop up satnav hooked in I am not sure if I need an uprated version ? I wonder if the IS200 SE bumps the amperage an hour rate up from a standard battery. Also - any news on of the altezza and is200 batteries are the same size in the battery trays ? Hope somone has changed it and can help Muchas Gratious amigos Clond

Hello IS boys, I may need to change my battery on my import altezza. Can anyone let me know the amperage rate of the IS200's and are they different in the navigators and SE's to the lower spec. I need to source one and I am not sure as to what to go for as I have a sat nav and 200 watt amp under the seat. All info kindly accepted ! Before I get the look at my battery comment - I cant read japanese :)

My radiator has blown - is the radiator on an Altezza 4 pot the same as the supra/mr2, like the is200 or defintive to just the Altezza ?

Fitted new sensor - emissions down to 0.7 (need 0.3) and 233ppm (need 200). Where now ??? Sensor was tested and was intermittant. Do I reset the ECU - what problems will that cause, more or less ? Most seem to suffer some problem by doing this, but, based on a dodgy sensor might this work. ECU light not on, which is expected as it runs on default. Anyone any thoughts ?

Bang on - manual Z edition Looked in exhaust, looked in engine management, didn't look in switches. £165 from Toyota .............WOW ! £49 if it had been a celica from a well known O2 sensor outlet !!!

Still not sure what section you found that under but you are the man Mr E910

Lots of views Little in replies !!!

Does anyone know the part code for a Lambda (Oxygen) sensor that connects to the exhaust for an altezza. Not a good day - well over limits and the car I bought has a custom exhaust - not sure if it has a broken cat or just doesn't have one :( Failed on CO2 and Lambda - he tested it as an IS200 quoting a reading of 0.97 - 1.03 where the car reads 0.84 Brakes and disks allround need replacing and a bulb ! So has anyone an idea what the lambda sensor part is ??? Can't immediately see it on Toyo mods.

Same on mine, I had then on my Celica GT and thought they where quite cool. I have thought about connecting a wire to set them up but equally like you have no wish to pull the roof down to get a the curtesy light to install it. It would be interesting to see if anyone has done it or has any thoughts on it. Can we order the housing from Toyota ?

From above Found out i have a Z edition with A01B Torsen diff. Someone quoted the pre september 2001 models do not have LSD on any model, can anyone confirm this one ? Toyo Mods shows my car was built 12/98 - previously registered as a W reg in britian, registered 10/2001. What is going on ? help ?

At 36,000 miles one has to wonder what the hell has happened to it to have half of the problems listed ? Especially a clutch - was it rally'd ?