...Hmmm... well i'm a bit fussier!! got them in and ran the feeds for the electric adjustment part from the drivers side under the carpet, between centre console. Perfect. Works fine. chopped wiring for heated seats, connected all the same colours together and again, works as it should. Seat side airbag same as manual seat, no worries. Just left with no seat belt warning light for passenger. Might have another go tomorrow, but girlfriend leaves the damn thing off anyway, so light flashes annoyingly so may not bother. This is not as easy as the write ups above would make you think. Just be aware if you want later seats in an earlier (manual adjust) model, you can't just rip out the old and bolt in the new.
So to summarise-
Seat belts will not fit from earlier cars on later models - change belts or catches (I swapped catches on seats)
No wiring under passenger side for power seats - run spliced feeds from drivers electric side under centre console carpet (pain to do invisibly, but at least fused and constant power)
Wiring COMPLETELY Different on later seats passenger side, and manual adjust seat wiring ONLY side airbag connector the same.
Cut pink and black (dunno what this is!)/ white and black (earth)/ green and red (heated seat + feed)wires and join them all together to get feed for heated seats.
Not sure how to get seat belt warning light going but suspect pink and black has to go to some other coloured wires (black/blue!?)
Interior looks ace now, got a lovely new looking leather and alcantarra set same as mine but with piping and electric both sides... give yourself a few hours and careful with them airbags...!
Hi ,you said you ran spliced wires from drivers side to passenger side. Was this the white live wire only? and ground
