Coulwhip

Apoligies for the delayed update. I have noticed that the problem has gotten significantly better and less frequent since I have stopped using RED X fuel additive with E10. I have also noticed that if the problem occurs but the engine starts without me requiring to press the throttle, then the car will idle low at around 500 - 600RPM. Could this be an issue with my throttle cable? or I have read that it could be something to do with the VVTI solenoid? Or does it still point to a leaky injector? Thanks

The issue started before E10 came in. To be fair I have used a mixture of e5 and E10 since and I thought it made the problem more inconsistent. I will try and use super only for a bit. I would be surprised though, because from what I've read, these cars are running fine on e10

It idles fine. Aside from this startup issue, the engine runs sweet as a nut.

I replaced it because it was fairly deteriorated and scratched up. I suspected it a likely source of an air leak. It was a relatively cheap part so was worth a go. It didn't change anything though

The million $ question! I spoke someone knowledgeable, and he said if it were a leaky injector I would smell petrol in the car when the engine is running and I'd also hear a sucking noise. He said he thinks it is an air leak and reccomended I get a can of easy start and spray it along the air intake while the engine is running, and if the engine revs higher then where I have sprayed is there is an air leak. A good idea which I will try. I recently replaced my throttle body gasket and have made sure there are no obvious loose bits along the air intake, so I would be surprised, but like I said it's a worth a try and I will update

It would make sense if the high pressure is causing fuel to seep through somewhere, because I have noticed the problem does get worse if I drive my car hard then turn it off. I'll have to get on to my mechanic, do you know if you can test a leaky injector without having to take it all apart?

Could it be something to do with the fuel pump/fuel filter? Or would that cause problems on a fully cold startup can anyone tell me?

It only happens after the car has cooled down from being hot. But it could be that. Do you know what could be causing that?

I suppose I will have to get someone to thoroughly inspect it. I have my own OBD reader and the car isn't giving any codes for an issue though. There's so many things it could be I honestly have no idea

Update: I bled the system of air, but it has made no change to the problem. The car gets worse the longer I leave it cool. If I dont put my foot on the throttle and start it first time I won't even be able to start it without alot of cranking and feathering for a while. I have noticed though, it's almost like the car started then instantly stopped then the starter motor kept going. Almost if the car expected itself to start then doesn't know what to do when it doesnt. When the car does start it goes (bub ba bub ba bub) and with a strong smell of petrol. I'm thinking it's flooding the engine, but I thought petrol evaporated instantly?

Nice one lads. I'll burp the coolant system and see if that makes a difference. It will be a bit more awkward than normal because I have this japspeed rad with no bleed tap, but I'll manage. Thanks for the advice and I'll give an update when I have one

Thanks for the reply. Headgasket failure was something I was concerned of too. However I recently did an oil change and there was no water mixed in with the oil, and the coolant is as clean as the day I put it in. So I like to think that rules that out. I have noticed that the temp gauge seems to go a couple notches lower when I stamp the accelerator to the floor and rev the engine out. Not sure that is abnormal either as the thermostat is probably letting more coolant in? idk I have noticed the fan coming on randomly when the car is off and the ignition is on, it will come on for a split second then go off. But that literally happened for the first time yesterday and I'm not sure that's abnormal either. What other signs would headgasket/ cylinder head failure produce?

Hello, This is a bit of a long story, but I feel all this information is important as I cannot, for the life of me, figure out what this issue is. My IS300 will always start first time on a cold start, however if I warm the engine up and leave it to cool for about an hour or so, it will sometimes splutter/misfire when starting (See video). It will start if I feather the throttle and it doesn't even stutter if I start the car with my foot on the throttle slightly. When the engine has started it runs perfectly with 0 issues at all. Even stranger if the issue occurs but I get it to start, and then I turn the engine off and start it up again, it won't struggle to start at all. This issue first occurred soon after I was doing a coolant flush and I forgot to burp the system to release air pockets and I overheated the car very slightly. Whether this is related to the issue or not I don't know, as I am unsure whether the overheating actually caused any damage. I have replaced the spark plugs, ignition coils and HT leads since this has happened and it has made no difference. I can't imagine it being an air leak as it is too inconsistent, so I am wondering if it is something to do with the car not injecting enough fuel ? This has been bugging me for a while now and I was hoping someone on here might have an answer. Any help is greatly appreciated. 20220301_203018.mp4