Autoelec

Thanks for that reply, there was nothing to correct other than the osf "toe" seemingly when the car was in the body shop there was an "event" but overall smart car no wear... :D ← Yes, sorry Tony should have explained things a little better.

Just a quick note to say what a top bloke Dr Bones :P (wheels in motion) is and how important it is to check the suspension geometry. Tony adjusted mine about two thousand miles ago and said to come back for a free recheck/fine tuning for FREE. Went to Watford yesterday and the settings were a little out (Tony said the car had hit a pot hole). He also assessed the tyre wear and advised to up the pressures to 35 all round. It is a small price to pay for the savings you will get on tyre wear.

Hi, does anyone have a quick shift for sale or know of any group buys?

Couldn't agree more. He is a top bloke.

unfortunately that ran out in December! only started this month misting ← assuming there is no crack or hole in the glass the most likely cause is the seal that bonds the glass to the unit is incomplete and allowing moist air in, also check where the bulb fitment enters the light (these are standard lights, right?) there should be a rubber grommet there is this fitting ok? there is a post on the forum explaining how to dismantle the headlights and remove and refit the glass, i can't remember where though. ← Probably best getting a new head lamp. will try on e-bay ← I had the same problem, car was three years old and the dealer changed it for free. :D

I had the same problem on the left hand front wing (51 plate) Lexus had it for repair on Monday and it wasn't sorted to my satisfaction. Going back to the bodyshop again on the 21st. aaaarrrrr :tsktsk:

he will be a long what exactly? :P check out this thread mate, and pm wheels-in-motion, thats tony. ← Went to see Tony on Friday. What a transformation, I can see why he is highly recommended. :D ← Just set the geometry correctly (which the Lexus Dealer seemed incapable to do!)

he will be a long what exactly? :P check out this thread mate, and pm wheels-in-motion, thats tony. ← Went to see Tony on Friday. What a transformation, I can see why he is highly recommended. :D

Thank you.

Thanks, how can I contact him, sorry i'm new to this.

Just wondering if anyone has come across a 200 SE Wandering and pulling over an uneven road surface? The car (a 51 plate) has been back the dealer twice now (they did a four wheel alighnment) and is going back again on Thursday! If the alighnment and bushes/ ball joints ore ok the only thing I could put it down to is the Avon tyres which appear to have a very "square" side wall. Any help would be appreciated.