Initializing Windows after battery change



When you change the battery you MUST re-initialize each window in order to be able to control each from the drivers door switches.

In order to do this you perform this operation at each window using the switch on the door for the window you are at. If you look closely at the small led on each switch you will se it is blinking - this indicates the windows need initializing.

1. Open the window halfway using the door switch.

2. Fully close the window by pulling the switch and continue to hold the switch up for 4 seconds or so.

3. Do this at each door.

When complete the blinking will change to being a constant glow ie 'on'.

Your windows will now fully function again from the driver's door control set.

Recommended Comments

Didn't think i would need to do this after a simple battery change, but as usual was glad i came across this article as it has saved me a lot of trouble.


Share this comment

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now