gwin

Had this issue recently, quite an easy fix.  it's to do with the rear fog switch.

take the 2 light bulbs out inside the switch, press down on the 2 pins on the short side to release the body out of the case

pop the top cover off the chip board

You'll see a L shaped copper piece, this is the problem.  you need to slide it back up into the case curve bit pointing into the spring bit, it'll fit exactly.  Use some superglue to make sure it stays in place.

Put everything back together.  Save yourself $50 for a used switch or $120 for a new.  Buy me a beer instead.

Bump this old post, but I have this problem today on the way home.

I have a HKS FCD though... what settings do you guys dial at?

There are two ways to setup the supercharger.

I've removed the bypass valve and swapped it in for the blow off. Now the compressor surge is take care off, I've also swapped the dual port intake for a single 80mm intake. These are how the fords are setup.

why?

Ok i figured out what's wrong, the spring rates were too high on the greddy RS

I've used the smaller spring but that's too soft, I'll go home and try the tougher spring after work.

Hello

Installed the BOV today, but it's not blowing off :P

any ideas?

the short answer is yes

Hi guys

Those of you with Turbos and S/cs, can you help show me where I hook up the return vacuum line from the BOV please?

Is it the same line you use to tap the boost gauge?

pics would be great

Thanks!

I followed the ECU pinout, using the VSS from combination meter, but i'm not getting a signal.

THere are three others, Speed signal IG, IE and SE, do I use these? which one do I use?

Are they custom? wahts the setuplike? still going ahed wtih it? i'm in Sydney, and a few of us might grab some too

yea its just to the right of the radiator when you're standing infront, its a ... shape of a ... hmm, quadrachon, a shape that has 4 sides, but doesnt look like a square? hahah

Thanks guys,

I finally got round to installing the SAFC, big thanks to maferga and grahamd for their contributions on the ECU pinouts.

Car's all good now! Anyone need help with installing one let me know, i'll be glad to pass on the knowledge

BTW, anyone installed an aif/fuel gauge? which sensor do i tap that to? OXY1?

Hi

I know for sure we're on different engines, 1Gfe and 2jz

Your IS300 2jZ is bigger than our 1Gfe, SO your exhaust spacing is probably going to be further apart. I would recommend NOT to do it.

Thanks guys, yea I don'th ave a SC extension, its not common down here in Aus.

thanks man, Ecu extension and SC? sorry what is that?

Hi guys,

Anyone have the SAFC I or II in their IS200? Those who know their stuff, what pin outs do i connect the wires to? I have the diagram, but it's missing a few variables.

Thanks in advanced.