Stetz

Are you talking about the rubber seal ? I think my problem is with the runner the glass sits on ! I dont want to go to dealer, would a windscreen replacement place at a look do you think ?

Lads, I had a major problem with the sunroof this evening. I got into the car and opened the sunroof as normal (no issues with this) then when I had arrived home and tried to close it, all it would do was to close a short bit and reopen. I did this a few times, so in the end I had to inch it closed. I tried the tilt which is fine, I tried it again after I got it closed and hapened again. So its staying closed till I figure out what wrong and how to fix. Any idea's ?

mmmmm, light weight version. Didnt know there was one for the IS200. I'd say there pricy though.....

You guys have any idea if I need new buttons or can the bulbs be replaced in the TRC/Snow/Drivers heated seat buttons. I ask as I had to replace the button for the A.C. in my old Vectra.

Cheers

Anyone know

Just wondering if the gearbox mount could be worn of something, as when I'm at the lights and drive off in 1st gear there is a wobbel from the car. If I rev high taking off its not as bad, just trying to sort problem before it gets worse.

You guys have any idea if I need new buttons or can the bulbs be replaced in the TRC/Snow/Drivers heated seat buttons. I ask as I had to replace the button for the A.C. in my old Vectra.

Cheers

Any update on this, would it be warped disc's. I hear a the very same noise but not sure if it's front or rear. I also get a bad wobble from the wheel when i brake hard.

Just a quick question about programing a new key. What is a master key?? all i have is a 2 button key which is about to fall to pieces and i got a new 3 button type on eBay, am i fecked or can it be done.

Just doing a bit of research on this topic, & i found this DENSO iridium POWER iridium TOUGH

IS 200 - 2.0 i V-6 24V (JCE10) 114 1GE-FE 01/'99-> SK20R11 IK20 VK20

What the hell are the iridium tough plugs ??

Ok, i am just wondering if the bulbs need replacing of the whole button. I had to change the button on my old Vectra before and was quite pricy. Only the light comes on when i press it, but at night u can't see the button, if you get my drift...

Sorry lads, just a little of topic here. I just noticed that one of my headlight washer units is up a little about 1/2 inch from the bumper. But i tried lifting it and letting go and it just sits back in the same spot. Any thoughts ??

Well its the OEM one's, there gone very 'crackley' so i was looking to change them...

Right, i see i have an amp under the glovebox, so i've either the se or sport yeah ??

If so what replacements can i get ??

it does depend on wether the car is an 'S' 'SE' or 'Sport' as to what speakers you need matey.

How do you tell the difference between them ?? I can olny see a pair of wires going to each speaker !!

Anyone ???

Cheers P.Lindblom, but i was wondering how easy it is to remove the controls from the centre console....

I did the unthinkable, i spilt coffee on top of the controls. Tried to wipe away as much as possable, but now some of the buttons are sticking now. Just wondering how hany they are to remove to clean under neat them.....:(

Just wondering how handy the removely of the sat nav controls are on a 03' as i think someone was spilt on the controls before i both her as some of the buttons do not responed when i need them two ! :(

I bought a UK import IS and it had the orignal disc in it{03} with Ireland was not covered. So i bought the update and works no bother. If your in the area around Dublin thewaterboy, give me a shout and u can check my dvd in ur machine !!

That's damn s""t hot mate, looks better than it would from new in a showroom........ :P :P

Is this the only after market filter that can be got for the IS

The only place i can think of would be, westward engineering in Enfield.

Hi,

Hope you dont mind be joining in, but didn't seem any point to start a new thread...

I have like a constant whistling on my clutch and when i touch the clutch pedal a little it stops, ive been told that its the realease bearing on its way out and although it's not causing any functional problems it's annoying...

Could you guys tell me how much i should expect to pay for a new clutch and if its worth getting an uprated one other than standard? the benefits etc?

If you could point me to a clutch kit that will do the job that will be much appreciated :)

Cheers guys

I've the exact same problem, but i've a ticking sound than a whistling type and the clutch pedal sqeaks when pressed

OIl level is 100%, only happens every now and agin though.........

Any thoughts !!!!!!!