auditray2007

I have just swapped over the ABS ecu from another 400 but no change. However when I put the ecu back into the doner car it too is now showing the same warning light. The doner car was "faultless" prior to that. What does that suggest?

No bulb blown. Its a simple system and all checks out. I have to think its a code issue then. Is there another way to clear the codes besides disconnecting the battery of fuses?

Hi Guys, I have a "Brake wear" warning and indicator light flashing on my 1999 LS 400. All the pads are 75% and more. I did a Continuity test and there was continuity in the sensors. Fluid ok and disconnecting the fluid sensor changes nothing, I fitted different pads with sensors also . So two sets of sensors (which all check out ok anyway) and by passing the sensors does not put out the light. The rest of the system checks out ok also. I have read many posts but no info relating to this particular issue. Is there some way to reset this light. Tried the battery disconnect for hours at a time but to no avail Does this light suggest any other fault in the car outside of the brake system