Akite

It was £1600 but i needed x2 new sensors as they could not get them off the old manifolds and a new bracket as it had rusted out.

Update - manifolds went on fine ticking now fixed. I do however now have a fitment issue with what was an aftermarket exhaust system (on the car when i purchased it). The manifolds dont connect to the rest of the exhaust correctly so i will have to get the exhaust altered so the joints line up 100%. Bit of a pain but will take it to Hayward and Scott to do the business on this.

Took my ISF to Westfield Motors with the manifolds above. Ian has done the work and i will pick up this weekend. Will update you all after. Wish me luck!

Hello can anyone tell me if the interior floor carpet from a IS 220 is the same as the one in an IS-F? Im not talking about the floor mats but the entire floor carpet. Thank you for your help.

Hello again so ticking on cold start, yes. I also get a petrol smell if i ever put the foot down. So then using a borascope looked at the manifolds (not easy fyi) and i could see a hairline crack around the rear driver side port.

Thanks for your help everyone

Hello. Does anyone know what the little pipes at the base of the manifolds are for on the ones pictured above? They are screwed in after the cats.

When you say a set what car are they from?

Does anyone know if the rcf/gsf manifolds have the same fitment to the rest of the exhaust on an isf? Just checking they will install without having to replace the entire exhaust.

I would get the PPE ones just cant afford them. I can get a used set of RCF ones for under £1k from an RCF that had under 20k miles on it. I will give this a shot. I just hope im making a good decision as its the same as just replacing the stock one with new. Thanks for your help.

Yes i did read that one but i was not sure if these are exactly the same as the ones that where used.

Hello to you all. I have the dreaded cracked manifold on my 2008 ISF only 65k miles 🥲. I want to know if i can fit the RCF manifolds to my car as they are far better quality and design i believe. I can bue these 17104-38090 17105-38090. See image. However before i do i wanted to know if this will cause me any issues or if you had any other suggestions? I want to be able to pass mot and want the car to last as long as possible. Thanks for your help