Kryz

Has anyone out there tried putting an LED bulb in a Lexus? Does it show up a warning light or not?? Anyone out there?

Hi, I have a Lexus GS300, and I am thinking about replacing the rear brake light bulbs with LED bulbs. Do i need load resistors so the warning light doesnt flash up? Or will I be ok without?

It looks like the correct part. I am confused does the ball joint splitter aid in removing the nut? do I remove the nut first? ??

Does anyone have step by step guide to changing the part/parts?

Would it be diffiecult to fit http://cgi.ebay.co.uk/ws/eBayISAPI.dll?Vie...p;rd=1&rd=1 And how long would it take? Any special tools needed?

You have just described Exactly the same noise that I got. I sprayed a load a grease onto the joint. Stopped the noise. Should protect it for the time being. Got my car booked in. I just hope it doesnt cost the earth. The GS300 is a rear wheel drive

The Car had the Ball Joint LWR and Control Arms replaced less than a year ago. Would this have been changed at the same time? Cheers Would these replace this item? http://cgi.ebay.co.uk/ws/eBayISAPI.dll?Vie...mMakeTrack=true Would this have been replace when the ball joint and control arm was replaced? Or can i just replace the rubber?

The Car had the Ball Joint LWR and Control Arms replaced less than a year ago. Would this have been changed at the same time? Cheers

Cheers. Next question, how long do the ball joints usually last?? Cheers

OK i have taken my wheel off and found the problem I think. I have added a couple of links to pictures. any ideas what needs replacing? Is it the whole arm or just the rubber bit.

I recently got a new tire on my passenger side front wheel. Today I noticed clicking when I took a left turn. The clicking was from the drivers side wheel I think. Any ideas what it could be from. No clicking when do right turns. I had a look and couldnt see anything that would catch the wheel. Help?

My dirver side break light is out. So i take of the unit and check the light and it doesnt work. I take out the bulb, and put it back in and it works for a bit. THen the dreaded (!) comes on. THe light is out again. Its not the bulb, I dont think. Has anyone else had this happen?

Anyone Else have any ideas? I have checks 2 types of universal fit sensors and they both have the lower resistance. Does anyone know is the extra current would blow/fry anything??? Dont want to break my ECU or anything!!

If your sensors are 4 wire then you can get 4 wire sensors from the UK. Try searching for Lanbda sensors on ebay uk.

Anyone Else have any ideas? I have checks 2 types of universal fit sensors and they both have the lower resistance.