alberthaynes

Yes and y does it go after a few stops and pulls away in traffic

Had front callipers replaced less then 5 months ago and only done 1000 miles since then.

No it's just through the front wheels, steering wheel is fine, it like the front is locking up if that makes sense, it does nothing else but even vibrate the front a little on pullin away but it's stops after a few miles in traffic from stoping and pulling away

Anyway one know y I hav a judder from the front wheels? It only happens for a few miles when I stop and start in traffic or pulling away at a junction, then it disappears, until I use the car again a few hrs later or the next day. I don't get a Vibration through the steering wheel just the front wheels

Wheels, brakes

Hi guys. Just a question. When driving at nite I hav noticed that my door controls don't seem to illuminate up part from the drivers window switch and the front of the door (all) locking switch. The rear and passengers electric window switch don't illuminate. Is there away to make these illuminate for ease of use at nite time driving or should these illuminate as standard?

May thanks :0)

Hi guys I have looked to see if there is a blog about engine cleaning and I can't find one. Just after some advice as I plan to steam clean my engine bay as it v dirty and dusty. What areas should I be careful off or stay clear off? I plan to cover the battery and fuse's etc.

I don't think it was ever fitted.

Clifton 94 great help many thanks ya a star :0)

I went to kwik fit and it was £6.50 per wheel to balance. Not bad really

What is wrong with adding a dummy LED? what harm will it do, if I get an after market alarm it will come with its own LED. Many thanks steve2006 but not to worry!!!

Hi many thanks, I don't know much bout wires, I hav a connection that goes in the the ignition barrel with 6 wires, what colour would this ignigtion warning light be?

Could sameness help. My car doesn't have an alarm at the moment just the immobiliser which has a flashing LED on the dash. I would like to for the meantime and a fake car alarm LED till I source an alarm out. My question is I want to run it of the ignition to flash when the key is removed, I can only seem to get it to flash when the key is at ACC, I know which wire is the poss + but where is best to place the neg - for this to work when the key is removed?? Your help is grateful

Is it easy to paint the callipers? I see there r two silver clip looking thing on the front, do these come off easy or do you just tap them up and paint?