Do Not Sell My Personal Information Jump to content


Established Member
  • Posts

  • Joined

  • Last visited

Everything posted by TommyH

  1. Think it's THESE your looking for mate.
  2. Hi mate, just take the emblem from your air filter housing under the hood.
  3. I have the TRD front splitter also, and the reason i took the fog out from the front was it looked as if i would have needed to cut the inner arch liner.
  4. You can take the fog light out from the front. The light has two bolts (10mm i think)at the side. You get to them from the air vents, just undo them and the fog pops out with a bit of force.
  5. When replacing your balljoints,e you ned to get the Geomtry re-done.
  6. Yes, straight fit mate and HERE you go. Good Luck.
  7. TommyH

    Front Door Cards

    Sorted, please close.
  8. That looks great. I think with a TTE rear skirt, TRD side skirts and a Legana bumper, this car would look fantastic.
  9. Did it leak before you got the pump changed ? If not, i'd take it back to the guy who changed the pump and tell him to fix it.
  10. Hi folks. I'm looking for some advise. I got myself a secondhand pair of front fogs but didn't realise the fog connectors changed from HB4 to H3 in 2003. My question is, has anyone got any advise on how i could make the newer 2003 connectors fit in my older 2000 connector ? Is there a wire i can buy to reverse this. Cheers.
  11. TommyH

    Front Drivers Fog

    Been keeping an eye on e-bay also mate, but some people are asking £70 :o Most say bulbs included which to me means they have the same problem as us with the holders being corroded and the bulbs are stuck.
  12. Hi folks, looking for Drivers Front Fog, as my bulb went and when i tried to change it, was well and truly stuc. So had to bust it and use tape to hold the bulb in. Cheers
  13. TommyH

    Shim Pads

    Wee bump :winky:
  14. Hi mate, welcome. Have a look at THESE There is lots to choose from. The Mintex one are suppose to be good. Good luck.
  15. TommyH

    Shim Pads

    Hi folks, looking for two shim pads. It's the slotted ones im needing. Dont fancy paying £40ish for a full set when it's only the two i'm after. Cheers
  16. Hi mate. It's the caliper carrier i think your talking about. You need to get caliper sliding pins, which you can order from Lexus, think they cost about £8 each. You get two to a caliper, ones the main pin and the other is the sub pin i think you call them. I'd go back to the place that did/didn't fit your disc's and pad's, it's obvious has hasn't tightened the bottom slide pin.
  17. Dont know if it's THESE or THESE your looking for.
  18. Lexus do the slide pins for about £8 each.
  19. LEXUS IS200 99- Dip Beam - 9006/HB4 Main Beam - 9005/HB3 Sidelight - 501w /T10/W5W Side Turn - 501w /T10/W5W Front Fog 99-2003 - 9006/HB4 Front Fog 2003- H3 Sportcross front fog - H3 Rear High Mounted Stop Light - 955 / T15 Licence Plate - 501w /T10/W5W X 2 Rear Fog - T20 /7440 Reverse light - T20 /7440 Rear indicator - amber 581 Stop/Tail - R580 /w21\5w Interior Middle Dome - 269 /festoon 31mm Interior Front - Ba9 Glove Box - R286 / 5mm Ignition barrel ring - R286 / 5mm Door Marker lights - 501w /T10/w5w Boot Light - 501w /T10/w5w
  20. On the back of the headlight their is a little sponge to absorb moisture. Try replacing this with a cut piece of any old sponge.
  • Create New...