Code 55 No2 Knock Sensor Signal

[Ian Lord]

After changing the oxygen sensors I removed fuse as per lexls website which should clear the fault code and stop the engine warning light coming on.

But the light did NOT clear

So just did the code check again with the paper clip

and I am now getting code 55 No2 knock sensor signal,

So I now need to address this issue.

Does anyone have any feed back on how to solve this?

I read it can often be the cable or connections rather than the knock sensor it's self.

I would welcome feedback also where is this located, I think in the "V" between each bank of cylinders below the intake manifold? but which is No2 and is it easy to get at?

I look forward to any feedback

Regards

IAN

[Mybikes a cx500]

I believe they are under the manifold, so no, not easy to get at. I would be hoping it was a cable or connector before they disappear under the manifold

[mr2lad]

I had a faulty knock sensor bank2 a few years back ...took to lexus and it was a near full engine strip down to replace