Flashin Brake Lights

[jay_russell]

you can get dual load resistor for brake side light.

the fogs don't have a warning light

nor does the middle brake i believe so it's just the brakes

and i'm not sure but i think it's only the brake lamp part that has the warning light.

[bensyer]

I had bulb out light when side light went, thats why i asked.. thiking what stav said i going to leave the 3rd brake for min, i thought about doing it as it might look out of place, but then like you said it may look like a disco and i dont want that either lol.. do load resistors normally get hot, I was looking on eBay for them andit says these units get hot.. so many choices ahhhh

[sparkystav]

yes they normally get hot.

[bensyer]

ok coool thanks !

[jay_russell]

but if you look you can get dual ones

http://www.auctiva.com/hostedimages/showim...,0&format=0

[bensyer]

yup got the dual bulbs, but they have there own feed, hence the 3 wires that goto the holder, or do u put the resistors on the negative line

[bensyer]

Hi, i done the fog to side and brake conversion with the dual holders.. and now have fitted 4x leds, now this brings on the warning lights, bulb out and the brake warning which i assume is again saying you have a brake bulb out, now looking at how hot load resistors get im not all keen on using them , seems like a fire hazzard to me? im going to use them on the brakes cos they only on now and then, my question is , instead of putting a load resistor on the side lights, couldi just not remove the bulb out light from the speedo? or does this effect the ecu in some way etc

[jay_russell]

yes you can remove it without problems

[bensyer]

cool ill do that then cheers