Standard Exhaust Tailpipe Trim

[Parf]

I know this sounds a bit chav but until I get my twin exit custom exhaust made im looking for a stainless tailpipe trim to hide the brown one thats there at the moment.

I have a standard exhaust with the 3" tailpipe but I cant find a trim that goes past 60mm which obviously wont fit. I ideally would like it to go from 3" to 4" to fill the cut out in the bumper.

Does anyone have or know where I can get one of these. Ive asked a few shops but they were more than unhelpful.

[aztecbandit1]

Do you mean something like this? eBay item number 150286498339

click me..

[Parf]

That would be perfect but its 330mm long and from the back box to the bumper is only about 150mm max so it will stick out loads. I could cut it down but then I will either loose the rolled end or the mounting bracket.

I think im going to have to go for a 3.5" weld on type which is about 84mm ID so it wont move about much and self taper it to the original tailpipe.

Thanks for the reply.

[aztecbandit1]

I thought when i read it was 300mm that it would be too long, But thought it might of been an error in the advert as i've never seen a tailpipe trim over a foot in lengh?

If i find any more mate i'll let you know :D

[Parf]

In the end I got a stainless weld on 90mm pipe, drilled a hole and screwed it on from underneath. I dont know how much the genuine Lexus ones are but I think they are chrome and this is a stainless one and only cost me £20 from eBay.

Just thought id post up a picture for everyone else with a standard exhaust. It looks a lot better than the black end i had before.