ormi
-
Posts
3,115 -
Joined
-
Last visited
-
Days Won
1
Content Type
Profiles
Forums
Events
Store
Gallery
Tutorials
Lexus Owners Club
Gold Membership Discounts
Lexus Owners Club Video
News & Articles
Everything posted by ormi
-
take the pipe off the pump and block it off mate
-
its fine......
-
course you can replace the top ball joint on its own.......£30 for the pair remove the circlip that holds the balljoint in hit it hard with a hammer out pops the joint then hit the new one in and put the circlip back on job done.....
-
right im confused??why are you needing to clean your cat??and in all my years of being a tec(15)ive never heard of a dirty cat!! what is the actual fault??also you have three cats two on the manifold and one under the car which is the main cat..
-
i would just get the fly welded if mine went..
-
that wont get rid of the judder if you have a judder the judder is caused by worn dampers in the fly its self..
-
timing belts a must also toyota oil is fine and not expensive..
-
can you spin it and hear if their is any noise?you dont normally have any play left or right
-
so how does the projector attach? you say it just screws in?? also had hid full beams for 3 years now and they are still going..
-
in and out or right and left?and what you mean slight mm cm inches? the kit on my car is a standard kit mate that i fitted....tte front bumper(bit cut out for intercooler,trd side skirts and trd rear skirt
-
their should be around an inch of clock wise/anti clock wise movment mate...and do you mean clean the inside of the bell housing??if so brake cleaner if you mean outside a good degreaser and power washer but remember and cover up the hole were the prop goes
-
you must not be able to turn the clamp round it must be tight...if it cant be tightened then replace it
-
18,s may spoil the ride , look good though :winky: the 17,s will fit though ? not really mate the top of the range ones came with 18's ie the ones with the bodykit
-
remember the sport cross 17's are diff from the saloon 17's they are wider at the rear..you have to go 18's at least..
-
caster arm for the front??
-
Lexus Mot Fail Front Suspension Bushes Split!
ormi replied to AndyRob's topic in Brakes & Suspension
what did it fail for?exact words please....you cant fail a bush for being split also i would like to see how they seen the split its almost impossable to see the bushes.. -
bugger i should have bought one of these instead of the charger..lol oh ps no it wont work
-
to the above look at my car stats on my sig........but you will need to run 215 tyres though...
-
never changed them mate but dont look too hard..but i dont think these would make the noise your talking about mate
-
Will A Short Shifter Made For A Usdm Lexus Is300
ormi replied to Stix's topic in Engine & Transmission
sure ive seen the same question elsewere and before this one was asked...?? -
40 offset is the correct offset for the car.......35 offset is wrong....
-
ebay...............lots and lots and lots on their
-
here you go... rear bushes
-
they are on ebay.....
-
Is200 2002 Location Of Radio Aeriel
ormi replied to XK8BMWLexus's topic in Lexus IS200 / Lexus IS300 Club
emmmm dont know if this is a laugh but the thing that points upwards on the roof is what your looking for...its standard